Create a file on magnetic tape: Difference between revisions
Content added Content deleted
m (whitespace) |
m ({{header|ZX Spectrum Basic}}) |
||
| Line 12: | Line 12: | ||
DATA TO BE WRITTEN TO TAPE |
DATA TO BE WRITTEN TO TAPE |
||
/* </lang> |
/* </lang> |
||
=={{header|ZX Spectrum Basic}}== |
|||
The ZX Spectrum does not have file type extensions, so we save as TAPEFILE, rather than TAPE.FILE. We can use any start address, depending on where we want the data to come from. Here we dump the contents of the screen: |
|||
<lang zxbasic>SAVE "TAPEFILE" CODE 16384,6912</lang> |
|||
Revision as of 02:49, 17 November 2012
Create a file on magnetic tape is a draft programming task. It is not yet considered ready to be promoted as a complete task, for reasons that should be found in its talk page.
In this task, the job is to create a new file called "TAPE.FILE" of any size on Magnetic Tape
JCL
<lang JCL>// EXEC PGM=IEBGENER //* Create a file named "TAPE.FILE" on magnetic tape; "UNIT=TAPE" //* may vary depending on site-specific esoteric name assignment //SYSPRINT DD SYSOUT=* //SYSIN DD DUMMY //SYSUT2 DD UNIT=TAPE,DSN=TAPE.FILE,DISP=(,CATLG) //SYSUT1 DD * DATA TO BE WRITTEN TO TAPE /* </lang>
ZX Spectrum Basic
The ZX Spectrum does not have file type extensions, so we save as TAPEFILE, rather than TAPE.FILE. We can use any start address, depending on where we want the data to come from. Here we dump the contents of the screen:
<lang zxbasic>SAVE "TAPEFILE" CODE 16384,6912</lang>